Hello and Welcome! If you have a technical question please check out our Forums. If you have an order or shipping question please refer to our Customer Support page. Please see all COVID-19 updates here and thank you for your continued support.



Member Since: May 16, 2014

Country: Brazil

  • Hello, is there any command to work with different baud rate (other than those specified in the datasheet AT commands) for all communication protocols? For example baud rate in KWP 10.2 kbps, I can get this baud rate? if yes, how?

  • hello, I have a doubt with respect to the AT command used in this board .. How can I use an AT command to send a frame for OBD circuit as CAN, KWP (ISO), VPW / PWM? I could not find any command called sends frame or something like that can you help me? What I mean is, I'm trying to make a simulation of communication with a vehicle (without a vehicle) using only a computer and software that I created. Anyone think the problem that I was not getting connect and be getting FB ERROR as response stn1110 is because I really I need a real car for that? Thanks in advance.

  • Can anyone provide a guide on how to start the simulated communication (without ECU) with each protocol available on board?

No public wish lists :(