Due to the impacts of the coronavirus outbreak, we are experiencing longer than normal lead times on certain products. We encourage back-ordering out-of-stock items to receive them as soon as possible.

Member #557692

Member Since: May 26, 2014

Country: United States

  • Can I use this to route power from a Li-Po Battery through the logomatic to an Arduino?

  • Thank you! That was a very helpful and very knowledgeable answer.

  • Sweet. Last question, I swear, what is the formula to calculate the range from a newly adjusted gain (I saw how to properly adjust the gain on the board in your tutorial)? (I am trying to measure airplane engine noise, talking more 90 - 120dBs).

  • Thank you, that works pretty well! Also, that would technically mean that it only measures up to about 66db (if the starting point is 0dB). Is that correct?

  • What is the unit of the enevelope output? Is the value I get there directly dBs or something different? I am trying to make a simple Sound Meter.

  • I bought this to connect it to connect it to a Redboard but I cant figure out how to hookup it up. Which pin needs to connect to which?

No public wish lists :(