sirhannick

Member Since: June 1, 2014

Country: United States

Profile

Electronics Technician at Continental by day, maker & fabricator at home by night.

  • Do you have a Fritzing part/drawing for this?

  • You say this is new. What is the difference versus the previous part DEV-10039? Thanks.

  • Just purchased 5x of these for cost reduction build of a specialty “tester box” I’m working on. The last 3 units I made used an Arduino Uno R3. I’ve run into a snag on this build since switching to the Arduino Pro’s. First off, there’s the pin difference between Uno R3, which is easily resolved since I don’t need those extra pins on the Uno. I just cut them off my mating shields. However, the case I am using is setup (like most cases these days) for an Arduino Uno R3. The Pro is just a tad shorter in one dimension so I can’t mount it properly.

    Question: Has there been any thought to making an updated version of this lower cost Pro board that has pin and dimensional compatibility with the Arduino Uno R3? Most shields and enclosures these days are designed for the Uno. Thanks!

No public wish lists :(