Doing some holiday shopping? Please check here for shipping deadlines to make sure your order arrives in time.

Member #561797

Member Since: June 9, 2014

Country: United States

  • Hi, i'm using mpu6050 together with mbed NXP LPC1768, the connection is almost thesame with that of arduino. mbed mpu6050 Vout vdd GND GND P9 SDA P10 SCL then the Vio is connected to Vdd on thesame mpu6050. i was using pull up resistor of about 10k before but there was a fault somewhere which i couldn't trace,my teraterm was writing mpu6050 connection failed and my device Id gave me 0,though i did some soldering and it worked before even my code works very fine. I've tried continuity test and my connection is continous.AD0 is connected to ground.please can you suggest what could have happened to my imu?my mbed works well but does not see the 6050 but i have been using it before.

No public wish lists :(