Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Mark Fischer

Member Since: December 31, 2008

Country: United States

  • Second vote for Elliot's in Tucson AZ!

  • I'll second the request for either bare boards or more variety of fixed colors. Red, Yellow, Blue, Green, etc. A bare board would be great.

  • What's the default sketch that comes loaded on these? I managed to break my FTDI breakout board trying to get it hooked up to this, so I can't load sketches yet. I powered the board from ~6v on RAW. What I assume is the pin 13 LED starts to blink slowly, then faster and faster until it is on solid. Then it turns off and starts over. This is just different than the standard preloaded 'blink' sketch that comes on the Duimilanove, and I wanted to make sure the board is working ok, and not freaking out on me. :)

  • Anyone know of a switch or set of jumpers that could be soldered to the 3.3v / 5v pads on the bottom? I'd hate to have to break out my soldering iron each time I wanted to switch boards.

  • Second vote for offering the bare board. I bought the kit already, and its great for prototyping, but when you want to make something a bit more permanent, I'd love something with just the components you need.

No public wish lists :(