mud329

Member Since: January 19, 2009

Country: United States

  • Yes, an accy circuit would be ideal but where I have to package and connect this thing there are only CAN lines and B+/ground. So unless there is a wake on CAN I would not be able to put this in low power mode, hence risking battery drain.

  • Is it possible to use this board and have it wake on CAN activity? I'm looking for something that can be left connected to a vehicle battery feed, wake up when there is CAN activity and run some code / transmit some CAN messages, then sleep when the vehicle CAN bus goes dormant again.

No public wish lists :(