×

SparkFun will be closing early at 3:30 Friday 5/27 and remain closed Monday for Memorial Day (5/30). Orders placed after 2pm MT on Friday (5/27) will process and ship out on Tuesday (5/31).

Member #585931

Member Since: August 16, 2014

Country: United States

  • I am trying to use this board to setup the Xbee with XCTU. However, I cannot establish communication with the Xbee to the program. I am using the following connections: 5V ~ 5V, Gnd ~ Gnd, TX ~ Dout, RX ~ Din I also flipped the TX and RX. I first soldered two Xbee Adapters and they did not work, then I wired wrapped a separate one. These same Xbees also work with my Parrallax adapters. Is there anything that I am doing wrong or are these Xbee Adapters defective?

No public wish lists :(