×

SparkFun Electronics will be closed on November 26, 2020 and November 27, 2020 for the Thanksgiving holiday. We will begin normal operations at 9:00 AM Mountain Time on November 30, 2020.

×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

avatar

Fredrik Berglund

Member Since: September 1, 2014

Country: Sweden

  • Feed it with 3.3v on the VCC. That makes it not latch. How about that as a solution :)

  • I've tried to feed it 3.3v with internal pull-up from Arduino Uno. What happens is that it doesn't latch but works brilliant for detecting the magnetic field. Crazy and great!

  • I've been trying to configure the accelerometer interrupt to work for a few hours now. I'm a bit confused about how to get INT1XM to trigger properly. The data sheet is somehow a little bit weak regarding how it works. Ca you please show an example? I've been studying the library and tried to change the setup of CTRL_REG[0-3]_XM without any significant results. If possible, please post a simple example of the setup.

    Best regards, Fredrik

No public wish lists :(