Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Member #610095

Member Since: October 24, 2014

Country: United States

  • Hello. I have the El Escudo Dos set up as mentioned above. It's connected with the pins to an Arduino Uno board. I have the 3 Volt inverter, and I have my laptop connected wtih USB to the Arduino to load the program.

    I'm having issues loading the program though. It gives an error saying "Board at COM4 is not available" even though the IDE on the lower right portion says the Arduino Uno is at COM4.

    So I have the following questions: 1) which version of the Arduino IDE was used in this tutorial? I currently have Arduino 1.5.5. 2) which board is selected under Tools->Boards? I've selected just Arduino Uno. 3) which programmer option was selected? (ie AVR ISP, AVRISP mkII, USBtinyISP, USBasp, Parallel Programmer, Arduino as ISP?) 4) is there any additional config files needed to make the Arduino Uno work with the El Escudo Dos, or El Sequencer? if so, how do you load it into the IDE?

    Sorry for so many questions but I'm really trying to learn this, thanks.

No public wish lists :(