×

SparkFun Electronics will be closed on July 3rd, 2015 in observance of Independence Day. Any orders placed after 2:00pm MT on July 2nd will be shipped out after the weekend. Thanks!

GreyBadger

Member Since: February 26, 2009

Country: United States

  • Found problem : - don’t install R10 (330)!
    Can anyone explain what R10 is there for?
    Other than that, excellent device reads with in that measured on a calibration bridge!
    Good down to 1p
    Recommend it for any tech bench

  • Hi,
    Just finished building kit! Three resistors were missing!!
    When switched on it displays “3010”.
    When Zero pressed “CO” stays on permanently.
    I’ve checked (and some again) the board for errors.
    All voltages seem to be correct.
    Processor must be working because zero switch worked.
    Any suggestions?

No public wish lists :(