Hello and Welcome! If you have a technical question please check out our Forums. If you have an order or shipping question please refer to our Customer Support page. Please see all COVID-19 updates here and thank you for your continued support.
Track My Order
Frequently Asked Questions
International Shipping Info
Mon-Fri, 9am to 12pm and
1pm to 5pm U.S. Mountain Time:
March 11, 2009
about 12 years ago
With the board oriented with the LEDs down, and the ICs facing up, turn it so that the USB JST connector is on the left side
The pins (from top to bottom) are:
USB Data -
USB Data +
I soldered the cut Xbee header to a small board, then connected wired from that to a normal USB connector. It's working great!_
I have made my own USB cable connecting to the JST just like you have. When i power the board, it flashes a few colors, then keeps the bottom left LED lit. I have the board set up for single board mode with the input wire going into the same board's output. My computer cannot see this device. I have downloaded the VCP and D2XX virtual com port drivers. "ls /dev" in my terminal does not show the the tty.usbserial port. How are you communicating with this board?
Where is that USB cable? Can i get it anywhere else?
No public wish lists :(