Forget something during Black Friday/Cyber Monday? Check out the Week of Deals!


Member Since: March 16, 2009

Country: United States

  • Hi,
    I recently bought the GPS Micro-Mini based on the MN5010HS GPS.
    On the description of the product, you specify that there are selectable baud rate and NMEA and SiRF outputs from a jumper on the back of the board. On my product, I don't have any jumper!!!
    Moreover the spacing between OPT1, OPT2, GND and VCC does not allow to connect jumpers.
    You have left OPT1 and OPT2 floating which does not allow to configure the baud rate, as explained in the MN5010HS Design Guidelines.
    What are the reasons why you left OPT1 and OPT2 floating, and how come didn't you separate them with 0.1" standard pin headers?

No public wish lists :(