Member #645731

Member Since: February 2, 2015

Country: United States

  • Hi I just purchased this GPS module and I can not configure at all. I would like to update it update rate but am unable to. I have been using the standard code found on Simon Monk’s site to view GPS messages at 1Hz. But I am unable to use the SkyTrack GPS software for anything other than reading. When I try to update any settings on the Venus chip I get an error saying “Target doesn’t replay please power cycle target”. Am I missing a serial command so that the software can communicate with the GPS chip? I’m pretty new at using Arduinos, I apologize if this is a simple question.

No public wish lists :(