JoshBreakstuff

Member Since: February 23, 2015

Country: United States

  • I’m curious as to why the NC on the high side is not another GND connection for VREF2 - the provided hookup diagram example shows the 3.3V and 5V GND connections tied together with a wire. Wouldn’t it make sense to just make the extra pin another ground? If you don’t tie the grounds together, the high side reference would theoretically be floating.

    Also, the description makes mention of driving an enable pin high. The schematic shows the enable pin tied to VREF2, so that should take care of it.

  • This requires the Arduino.org IDE and libraries (see the as of yet unresolved issues with Arduino.cc and Arduino.org). Additionally, the webserver example stops responding after a while. I recommend finding a different Ethernet solution for your Arduino project at this point.

No public wish lists :(