×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Member #657317

Member Since: March 5, 2015

Country: United States

  • Note to my future self. Don't order (3) coin cell batteries (CR2032) with your Almost Free Day SKU. Cheapest shipping was $15, and I went ahead with it without realizing that the batteries somehow changed the shipping cost.

    It wasn't until I placed another order later in the afternoon (for ONLY the Almost Free SKU) and saw the shipping was only $5, that I realized I screwed myself by including those coin cells. Adding insult to injury, I realized I had 8 more of these batteries in the junk drawer. Doh!

  • Well - I got this provisioned via laptop browser, and tried out a few of the demo projects on the android app.

    I then wanted to see if I could modify an arduino sketch that I use on for a simple Neopixel project. I got it working just fine, but now I can't figure out how to get the "default" code/firmware back on the board (so I can try some more of the demo projects. I tried loading the Blynkblink sketch via arduino IDE, but it doesn't seem to work.

    The serial output (via terminal or arduino IDE looks like this (repeated over and over): 8ŸŽþ‚ƒ‡‡þÿ[344] Blynk v0.3.4 [344] Getting IP... [647] DHCP Failed!

    Any suggestions?

    EDIT: I found the forum and posted this there too! EDIT 2: Solved. I found the firmware section on github and loaded the BlynkBoard_Core_Firmware.ino sketch. Thanks!

  • Is it possible to provision this board (connect to wifi) without the QR code card? I left it at work and want to experiment tonight!

No public wish lists :(