Member #659003

Member Since: March 9, 2015

Country: United States

  • Has anyone successfully hooked this up to an arduino uno? I hooked up the the pins as follows: GRN -> Reset RXI -> RX (tried with TX as well) TXI -> TX (tried with RX as well) VIN -> Tried 5V and 3.3V CTS -> GND BLK -> (No Connection)

    And powered the board using battery instead of the USB because I know that takes control over the serial port. Is there any way to make this happen without the use of the FTDI SmartBasic?

No public wish lists :(