×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

sylefeb

Member Since: April 13, 2009

Country: United States

  • Hi there - I just burned one of those by connecting it as follows: pin1 to +5V, pin3 to ground, collector (pin2) to the analog input of a PIC ds30f4011.
    Obviously I did something wrong. I am ordering a new one but would like to know how to properly connect these sensors? It seems other people had this issue (http://www.arduino.cc/cgi-bin/yabb2/YaBB.pl?num=1234777997/30) but I could not really find a satisfactory answer over there - and this information would be handy on this page (mis-configuration of the PIC analog input is unlikely: it does measure voltage properly when using regular resistors). I did verify the collector pin with a ohmmeter before wiring...
    Any advice?
    Thanks!

No public wish lists :(