×

It is that time again! SparkFun Electronics will be closed Friday, January 13th for our annual inventory day. Please keep in mind that any orders placed after 2PM (Mountain Time) on Thursday, January 12th will not ship or be prepared for local pickup until we open for normal operations on Monday, January 16th. In addition, tours will resume on Friday, January 20th. Thank you for your patience!

Member #6751

Member Since: August 1, 2006

Country: United States

  • How about offering an adapter so we can plug a pickit2 or pickit3 into this connector. Would need a .1" male on the pk2 side and an a 1.5mm female on the board side of the adapter.

  • The reference guide talks about a keep out area on page 9.
    “Keep out areas: There are two 1 mm round test pads on the bottom of the module. Avoid placing any exposed traces or vias in these areas”.
    The solder mask insulates the module from the ground plane on this PCB. If you ETCH your own PCB you will have to modify the board as indicated.

No public wish lists :(