×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Member #678953

Member Since: May 3, 2015

Country: United States

  • Using the Big Easy driver, 12VDC power supply and Arudino R3 and not getting great success. I'm using the example program and wiring shown in the Big Easy product page. With pot at low nothing happens. I turn it up about half way and the motor will jump a few steps but not rotate. If I turn the pot up higher the motor buzzes and the big easy shuts down for a while. Seems like its overheating. While the program is running and sending pulses the motor is locked tight, so I think it's getting the correct current. Seems like it's a timing issue where the motor is stalling.

No public wish lists :(