×

SparkFun Electronics will be closed on November 26, 2020 and November 27, 2020 for the Thanksgiving holiday. We will begin normal operations at 9:00 AM Mountain Time on November 30, 2020.

×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Member #687803

Member Since: June 1, 2015

Country: United States

  • Hmmm I am using a Piezoelectric Fiber Composite from ACI, which is listed on Table 2. My oscilloscope shows a peak voltage of about 40V, maybe that is too much for the breakout board?

    OK so here is what I am doing to test the LTC3588: Arduino Uno 5V -> LTC3588 Vin, Arduino Uno GND -> LTC3588 GND, Oscilloscope + Probe -> Vcc, Oscilloscope - Probe ->GND (different GND on the same side as Vcc)

    When I measure Vcc I am not reading any voltage. However, when i move the + Probe to D1 I am reading about 5V...what do you think?

  • hi, i have set up my breadboard in the same way but the LED will not light up. Will this only work with a certain piezo? Is there a way to test the LTC3588 to make sure it is working properly?

No public wish lists :(