×

In celebration of the 50th anniversary of Apollo 11's Moon Walk, we are offering $50 off our SparkFun Inventor's Kit for RedBot and the Arduino Engineering Kit while supplies last! Use promo code APOLLO11 at checkout until 11:59 p.m. MT to get yours today!

Member #695335

Member Since: June 27, 2015

Country: United States

  • The TPS61200 circuit is not working properly. The PowerCell board is brand new, I just unwrapped it. The LIPO is brand new, I just unwrapped it. Both just arrived in the mail from SparkFun. The output voltage is set to 5 volt on the board (the setting it came as). I plugged in the LIPO, its voltage is 3.83 volts. The output voltage (VCC to GND) is 3.17 - 3.19, no where near 5 volts. It's not working, may be defective. This is being tested without any pins soldered to it (bare), using voltmeter probes. The PS an EN are not connected to anything and are at 3.82 V (referenced to ground). It may be defective. I cannot get it to work. Help!

No public wish lists :(