×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Member #698852

Member Since: July 10, 2015

Country: United States

  • ify7i

  • Hi, I have a question regarding the schematic. VCC is the lipo positive terminal, that according to this schematic, is going to be connected to the VDD line through a 180 ohm resistor, to the ALERT pin through a 4.7 K resistor and to the I2C bus (SDA and SCL) through 4.7 K resistors. Shouldn't be a 3.3V regulator after the VCC line (battery) to have a stabilized voltage level on the I2C bus and on the other lines (not the CELL pin since the battery's capacity and voltage is measured there)? Best regards

No public wish lists :(