Member #704528

Member Since: July 29, 2015

Country: United States

  • Does anyone have problems with reading analog values using Edison and the Arduino block after power on/off?

    I have a stack with Edison/Arduino/Base/Battery: sketch reads analog value from the Arduino block and blink a light if the reading is greater than 0, or blink another one if it is less than 0.

    All works fine if I start the system with USB connected loading the sketch. I can disconnect the USB and the system keeps running OK.

    However, if I power off/on the system using the battery switch, the analog reading is zero, until I reconnect and disconnect the USB again, and starts working again.

    Any help would be appreciated

    The

No public wish lists :(