Member #757023

Member Since: December 30, 2015

Country: United States

  • There are two important problems that I had with this product:

    1. The pan servo has a annoying buzz when idle. I think this might be an issue of the code given that it has no problem when I tested with an Arduino.
    2. The mount does not appropriately hold the pan servo, when I “sandwiched” the pieces it has a gap of about 3mm, sufficiently for the thing to wobbly itself at each move.
  • Hi, I have the same issue as you, regarding the buzz in the pan servo. I changed the address in both in lines 16-17 and in line 29 ( so I can use channel 2, but I got the same problem. Did you do the same as I?

    Thank you.

No public wish lists :(