Member #779118

Member Since: February 26, 2016

Country: United States

  • In case anyone was purchasing this thinking it was open source and they could later make the machine any size they wish, this is definitely not the case.

    Official from Rob at Carbide that the extrusion is proprietary and will not be sold alone so your either stuck at your 16"x16" or forced into one of their upgrade kits in a size they determine and when they decide to release.

    http://community.carbide3d.com/t/so3-simple-solution-to-stepper-motor-tightening/1370/6

    I was sold on an open source machine and this is not. Just a caution to anyone else. The machine is a great hobby machine if your happy with the current size limitation.

No public wish lists :(