Andy13

Member Since: August 20, 2009

Country: United States

  • Product DEV-11168 | about 11 months ago

    So I am able to burn the bootloader via Arduino IDE (1.0.5) using my duemilanove as the ISP. When I try to then upload a sketch to the chip while in the sheild (using “Upload using programmer”), it fails with:

    avrdude: stk500_getsync(): not in sync: resp=0x00

    I was able to upload the sketch by putting the boot loaded chip in the due with no issues, but that defeats the purpose of having this shield. Any suggestions for troubleshooting not being able to upload sketches? Realize the 0x00 is a generic “cannot communicate error message”, but seems bizarre that it works fine for burning the boot loader.

    Anyone suggestions on “Upload using programmer” to With a duemilanove as the ArduinoISP, I am able to burn the bootloader for atmega328p just fine (done it with two different blank chips).

No public wish lists :(