×

With the recent surge in Omicron cases, shipping may be slower than stated times. We are working to build, ship and respond to everything as quickly as possible. Please see all COVID-19 updates here. Thank you for your continued support.

Takaitra

Member Since: August 21, 2009

Country: United States

  • The ESP8266 I recently received from SparkFun is running version 0.9.5 of the AT firmware with a baud rate of 115200. This was too fast for my Arduino (especially for software serial). To lower the baud rate to 9600 I had to connect it to my computer via FTDI and send it the command AT+CIOBAUD=9600. Also, the wiki link in the Documents section labels the inner pins as "NC". This is incorrect. The pins are labeled correctly at http://www.electrodragon.com/w/File:ESP8266_V091.png. Make sure to connect the CH_PD pin to VCC. I had to discover this via a lot of searching and trial and error. Hopefully this saves someone some time.

  • Thanks Blizzrad. I am running my ATMega8 at 1MHz and was getting garbage printed to the terminal. I switched to 2400bps and updated FOSC and BAUD settings. Now it is working great.

No public wish lists :(