Member Since: September 25, 2009

Country: United States

  • hi all
    I am using FIM3030 module and trying to interface it with my 8051 kit .I red in data sheet that module can communicate with different board rate but which is the board rate that use for start communication (default board rate).
    is there any example code is available for checking the module ?.
    there is three switches available for ENROLL,DELETE, IDENTIFY
    I connected this pins using the circuit(by default high,when pressing the switch low ).
    and it is working fine for DELETE,IDENTIFY key when I pressing this keys red light is coming in reader unit. but when i pressing enroll key it is not happening.
    (means no light in finger print sensor).why it is like that any problem with my module ?)

No public wish lists :(