×

SparkFun will be closing early at 3:30 Friday 5/27 and remain closed Monday for Memorial Day (5/30). Orders placed after 2pm MT on Friday (5/27) will process and ship out on Tuesday (5/31).

Member #83799

Member Since: September 25, 2009

Country: United States

  • I’ve been removing the wires and soldering the strips end to end directly so there’s no gap between strips. The only problem seems to be that it’s very hard to get a good reliable connection. I don’t think it’s the actual joint, but I think it’s been damaging the traces near the joint so I have to cut off a section of the strip and resolder.. Has anyone else done this and gotten consistent results?

No public wish lists :(