×

SparkFun Electronics will be closed on July 3rd, 2015 in observance of Independence Day. Any orders placed after 2:00pm MT on July 2nd will be shipped out after the weekend. Thanks!

3dotter

Member Since: September 28, 2009

Country: United States

  • I bought from you a AVR pocket programmer. I do not understand however what the Power Target and No Power switch settings mean.
    Are these settings to receive (or use) power FROM the target or to give power TO the
    target?
    Also it is not clear which voltage I have to connect to PIN2 of the 10 pins ISP progamming header when I am powering the target with a 3.7 V Lipo battery. My at90usb120 MCU on the target, which need to be programmed, runs at 3.3 Volt. Or can this PIN 2 be left unconnected?
    I am looking forward to your answer.

No public wish lists :(