wthompson

Member Since: September 29, 2009

Country: United States

  • Product SEN-09364 | about 5 years ago

    Hi,
    I want to change the firmware to configure the Accelerometer in 8 G or 16 G range at power up because I want to trial the sensor in a non-accessible location.
    I have modified the command to do this in the adxl_defaults() routine and recompiled the firmware using the WinAVR toolset.
    But I am not familiar with the Atmel processors or their programming tools.
    How were the evaluation board processors originally programmed via the USB ?
    What avrdude command or toolset can I use to reprogram with my new hex files? From reading the avrdude documentation it appears that the USB can be used but I do not know what programmer device to invoke.
    Any advice will be much appreciated.

No public wish lists :(