Frequently Asked Questions
Mon-Fri, 9am to 12pm and
1pm to 5pm U.S. Mountain Time:
Chat With Us
September 30, 2009
about 2 years ago
I read through this product and thought it was so cool, until I saw the cloud part….
Then I saw the comments below, lol! Love you guys.
Tutorial - The "Slap Method" for Through-Hole Rework
about 3 years ago
I’d suggest two things to help with this kind of PTH removal.
When you cut the plastic between headers, don’t cut the pins off. Heat the solder joint and pull out the pin with pliers on the other side.
To clean holes that have solder in them, strip a half inch section of stranded wire (22-26 AWG for these holes), and use it as a thin solder braid. Heat the wire as you slide it into the solder joint, and it will clean the entire hole in one sweep in and out.
No public wish lists :(
Forgot your password?
No account? Register one!