Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.


Member Since: October 8, 2009

Country: Finland

  • Say what you want but I am impressed! Just got one imp and after 10 minutes it was logging/displaying a smoker temperature in Xively with max31588+K-type thermocouple.

  • "but can't seem to figure out which of the wires in the motor cable match with which MOTOR pin on the EasyDriver board.". Use multimeter to measure the resistance between motor leads. Between two of them it shows few ohms, between another two it should show about the same value. Connect one pair to "A" and another to "B" in stepper card, if motor does not step switch A and B.

  • Just got three of these but...
    Installed it to Futaba 3010-servo, controlling it with PIC18F2550 (working i2c master).
    Servo acks every command I send but does not move.
    If I try to read something from servo, it always returns 255.
    Any ideas what could be wrong?

  • (New to i2c...) But what if I would like to use this adapter with i2c devices requiring much more power than what this can provide? For example few servos with "Openservo" (http://www.sparkfun.com/products/9014). Can I just hook up beefier power supply to i2c vcc and gnd lines or will it fry something?

  • Could one stack two of these with one Arduino-board and play two mp3s simultaneously?
    (I am a PIC-guy, done nothing with Arduino. Yet.)

No public wish lists :(