Member #863010

Member Since: November 7, 2016

Country: United States

  • I know this is an older post, but hopefully someone sees my comment. I'm rather new at all this, so I need some assistance. The directions say to cut the trace between the left and center I2C pads, but the picture is pointing to the space between the right and center. Could someone please clarify that for me? Do I cut the left one, then basically reconnect the two pads with the solder blob? If so, why not just leave the trace connected to begin with?

    Also, what's the best way to remove the capacitor in the first step? And do I remove it on both boards?

    Thanks!

No public wish lists :(