Track My Order
Frequently Asked Questions
International Shipping Info
Mon-Fri, 9am to 12pm and
1pm to 5pm U.S. Mountain Time:
Chat With Us
October 24, 2009
about 2 years ago
I'm looking to use this in a mostly-permanent application, and would like some sort of screw/bolt holes. Is it safe to drill small holes in the corners, approximately where the open source logo, and where the "M" are? There don't appear to be any traces there, just the ground plane copper.
News - SparkFun Gets a Cease and…
about 10 years ago
According to the SPARC website, a trademark is...
(it lists the various forms a trademark may take, and then continues)
"... that has been adopted by a manufacturer or retailer for use in connection with its products to identify their origin and to differentiate them from the products of competitors."
Section A. Go figure. ID Ten T error at its finest!!!
"... for use in connection with its products to identify their origin and to differentiate them from ..." here's the real idiot-confirming part: "... the products of competitors." As it has been stated, you're not competing with them, so the C&D is invalid, according to them.
Hopefully this will help prove they're wrong (contradictory at a minimum).
No public wish lists :(
Forgot your password?
No account? Register one!