×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Denny

Member Since: October 26, 2009

Country: United States

  • Pay attention to the datasheet for this sensor. When it says 5k load resistor minimum, it means it. Also, you need to switch this unit from a low heat voltage(1.4v) to a high heat voltage(5v) cyclically to achieve the desired results. In my testing I found that just leaving the heater on high gave diminishing sensitivity until I turned off the heater for a few minutes.

  • Have you wired in the backlight? That tutorial doesn't include wiring pins 15 and 16 on the lcd. I have hooked the backlight up to a pwm output so that I can turn it on and off via sketch.
    Hope this helps.
    Denny

No public wish lists :(