×

SparkFun Electronics will be closed on July 3rd, 2015 in observance of Independence Day. Any orders placed after 2:00pm MT on July 2nd will be shipped out after the weekend. Thanks!

jneuhaus

Member Since: October 27, 2009

Country: United States

  • I just got one of these (awesome!) but my gyro outputs look funny. The LPR output (after going through a PIC18F452 ADC) is pinned to 384 (ADC count), which is right where it should be for zero output, but instead of zero-mean noise, it’s like I’m only getting the bottom half of the noise. There are occasional bumps over 384, but it’s either that or lower, with a very flat top. The LY is fine, but the ADXL does it sometimes on a few of the axes. Anyone else run into this problem? It works so great otherwise that it makes me think I did something silly getting it set up!