×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Technogumbo

Member Since: November 4, 2009

Country: United States

  • I used a similar technique as nike to mount this to a pref board. I filed down the edges of the bottom pins on each side. I also left the side tab full size, but bent it sideways so a wire could be run through it and the pref board. I then soldered the wire on each side to help hold the connector in place as the much smaller center pins, after being reduced in size don't provide much strength.

No public wish lists :(