×

With the recent surge in Omicron cases, shipping may be slower than stated times. We are working to build, ship and respond to everything as quickly as possible. Please see all COVID-19 updates here. Thank you for your continued support.

Adam Dean

Member Since: November 4, 2009

Country: United States

  • The board has pins for powering the motors externally, but the hookup guide says that the DRV8835 H-bridge is hard wired to 5V. Do I need to disconnect the 5V hard wiring somehow before using the external power pins?
    I am using a pair of L-shaped TT motors and encoders and at only 3 Ohms of resistance I find that the motor needs to draw 1.7A to start from stall when powered with 5V. If I can power the H-bridge with only 3.3V then the current draw should remain below the 1.5A max and 1.2A steady state limit.

No public wish lists :(