Track My Order
Frequently Asked Questions
International Shipping Info
Mon-Fri, 9am to 12pm and
1pm to 5pm U.S. Mountain Time:
Chat With Us
November 9, 2009
News - A Few New Classes
about 6 years ago
how do you make this nice and aligned stencil plastic paper holes?
Any tutorial for that?
another inquiring mind
News - Baby Bluetooth
about 7 years ago
I would like to use it on a board which is running with 9V battery.
(every part connected to usb conector on this board will get 9V)
can the on board SMT voltage regulator will handle 9V, is there any comapny to ask?
try this page
about 8 years ago
I am trying to connect this sensor to 3.3v A/D micro controller (avr32)
can you advice about the needed range of RL
if I connect 220K ohm resistors as adviced, I get range above the A/D limit (around 4.7 volts)
the RL I get in my calculation is:
(5/(33+RL)) * RL = 3.3 ===> RL=64 ohm
but I am not sure I am doing the calculation right (where does RS go in those calculation)
No public wish lists :(
Forgot your password?
No account? Register one!