×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

ProfBob

Member Since: November 16, 2009

Country: United States

  • Hello Ken, Just looked up the data sheet and did the calculations for the volatge boost citcuit. Reisitor R2 should be a 15K. Check your board the resistors are to the right of the large capacitor and left of the word "color" the center 2 gray components. If they both say 3301 then SparkFun got a bad run of boards.

  • No Backlite boost voltage. Just received the board today and have the same problem as Ken-Hack. You can barely see the Sparkfun Logo. I checked the the voltage boost out at C3 on the schematic and it is 5V and not 7V as stated. The resistors next to C3 should be R1 = 3.3K and R2 = 15K, both on my board are 3.3K
    Can anyone verify the resistor values on a "working" board. Thanks

No public wish lists :(