SWR_DMaster

Member Since: November 17, 2009

Country: United States

  • Product BOB-08552 | about 3 years ago

    This is niether Male nor Female dependant. I spent two days tracking down an issue and it turned out that I had the signals going to the wrong pins. Well, wasn’t a problem with the breakout board. I placed a female DB9 on the wrong side of the board.
    If you have a DB9F the place it on the same side as the silkscreening. If you have a DB9M then place it on the other side. This will place the silk screening on the correct header pins.

No public wish lists :(