×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Member #920236

Member Since: March 26, 2017

Country: United States

  • The schematic says that there is a 220 Ohm termination resistance between A and B. But when I look at the picture of the board it shows that there is actually a 1.2 kOhm resistor present. Is there any specific reason for this? As normally for RS485 a 120 Ohm termination resistance is used?

No public wish lists :(