×

SparkFun Electronics will be closed on July 3rd, 2015 in observance of Independence Day. Any orders placed after 2:00pm MT on July 2nd will be shipped out after the weekend. Thanks!

William Marsh

Member Since: December 6, 2009

Country: United States

  • After looking at the AttoPilot some more I realized that they just rearranged the input traces slightly to make the ground take up one end of the board. There are two notches in my board instead of the holes. The in+ and out+ wire is supposed to solder into that while the ground solders into the end of the board much like the instructions indicate.

  • Hi I just got mine in the mail. I plan to use these to monitor solar power generation for a project.
    As soon as I opened the box I noticed that the in, ground and out traces appear to all be combined. There were no instructions. Also the board is slightly different from what is shown here even though it’s the same part number (SEN-09028). Each of the inputs appear to be two small holes. The three sets of two holes are separated by large holes. Do I use a Dremel tool or similar to cut the trace where it is thinnest?
    Thanks and best regards.
    Will

No public wish lists :(