×

Sparkfun support will be closed from 3:00PM to 4:15PM on April 27th for a company-wide townhall meeting. We will resume regular hours on the 28th.

Member #97533

Member Since: December 17, 2009

Country: United States

  • I am using the ProtoSnap and have a question. After uploading a sketch, if I apply power to the board though the RAW pin (7 - 8 Volts) the board does not execute the loaded sketch. If I cycle power (turn off, then back on quickly) the board initializes and runs the loaded sketch. Only power cycling works - using reset button does not get it to work.

    Has anyone else observed this behavior? Is there a solution / workaround?

    Thanks!

No public wish lists :(