×

Hello friend! SparkFun Customer Support will be unavailable today from 3:00 pm Mountain Time through the remainder of the day. We will resume normal operation at 9:00 AM Mountain Time tomorrow 6/20/18. Thank you for your patience!

Member #98282

Member Since: December 21, 2009

Country: United States

  • I’ve wired up this sensor using the datasheet circuit for “hardware interface” mode hoping to trigger a relay to turn on a lamp. Everything’s fine except somehow I have a normally HIGH signal (lights up the debug LED)) that goes LOW when it detects movement. I think the datasheet says it runs in an active low state. Anyone else?
    If this is correct, is there a relay that will open under current and close when the pin goes LOW?

No public wish lists :(