Member Since: December 27, 2009

Country: United States

  • Could this be fit directly into the power rails? It looks like the pin spacing might be a little too wide...

  • This looks like it would make a good insulator if you have a couple bare wires going through a tight spot.

  • I'm using a TI Burr-Brown INA125 OpAmp and with the right gain you can get about a 3V range out of the sensor. The datasheets are easy to read and have the circuit you need for a sensor like this already laid out for you. If you're going to buy one of these, its definitely worth taking a look at the INA125.

  • How is this different than using a bandPass filter in Minim?