×

SparkFun Electronics will be closed on November 26, 2020 and November 27, 2020 for the Thanksgiving holiday. We will begin normal operations at 9:00 AM Mountain Time on November 30, 2020.

×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Bob's Unkle

Member Since: April 5, 2011

Country: United States

  • I had some trouble too, I mixed up the RX and TX, so I defined it correctly in the software. Mine prints from the arduino and still has the weak flashes from the led. I assume you have the new soft serial as well. Also, I had the baud settings wrong. Check the printer defauld baud rate by holding the button on the printer down while plugging the power in. Make sure this is the same value in the software, and on the serial monitor. Hope this helps,

No public wish lists :(