Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.
Member Since: September 14, 2014
Country: United States
Product SEN-09836 about 6 years ago
I have interfaced this accelerometer to my atmega1280 board (not arduino). Written program in atmel studio 6. I have configured it for 3200hz data output rate, fifo bypass mode, using full resolution and range is +-2g. I am getting values ranging from about -255 to +255 (only gravity acting, not any additional acceleration). Am I getting right value range? Or is there any way to get more resolution? And when still data is fluctuating +-5. Is this normal?
Tutorial - ADXL345 Quickstart Guide about 6 years ago
Can I directly connect SDA and SCL pins of microcontroller and adxl345? As accelerometer is designed to operate at 3.3v and microcontroller operates at 5v. I have a 3.3v supply to power accelerometer but I do not know whether I can connect communication lines directly or not. PLEASE help.
No public wish lists :(