ACS712 Low Current Sensor Hookup Guide
This Tutorial is Retired!
Note: This tutorial is for the ACS712 Current Sensor Breakout Boards. If you are using either of the newer ACS723 Breakout Boards, please refer to the new Current Sensor Breakout (ACS723) Hookup Guide.
View the updated tutorial: Current Sensor Breakout (ACS723) Hookup Guide
Contributors:
AGlass0fMilk
AGlass0fMilk Resources and Going Further
The ACS712 sensor is ideal if you need to measure a small to moderate amount of current, especially if it's AC current! For more information about the ACS712, check out the links below:
- ACS712 Datasheet
- SparkFun Hall-Effect Current Sensor Breakout - ACS712
- SparkFun Low Current Sensor Breakout - ACS712
If you don't need electrical isolation and want to measure smaller currents, check out the INA169 Breakout Board. And for even higher power applications, check out the Non-Invasive Current Sensor - 30A.
For more power related learning, check out the tutorials below:
FemtoBuck Constant Current LED Driver Hookup Guide v13
The FemtoBuck board is a high-efficiency, single-channel constant-current LED driver.
Hookup Guide for the SparkFun RedBoard Artemis Nano
Get started with the powerful RedBoard Artemis Nano
Thing Plus Dual-Port Logging Shield Hookup Guide
This tutorial shows you how to hook up and use the SparkFun Thing Plus Dual-Port Logging Shield.
LiPo Fuel Gauge (MAX1704X) Hookup Guide
Monitor your LiPo battery with the LiPo fuel gauge! In this tutorial, we will be using the MAX17043 and MAX17048 to monitor a single cell, LiPo battery over the Arduino Serial Monitor. We will also connect a display to view the output without the need to connect the microcontroller to a computer.